粒子-转子模型和推转壳模型中的能谱统计分析

用粒子–转子模型和推转壳模型研究了6个粒子分别填充在单j壳和双j壳上的混沌行为.分析了单j壳和双j壳情况下能谱的最近邻能级间距分布和谱刚度随自旋及推转频率的变化,结果表明,当组态空间大小不变时,系统在双j壳(g_7/2+d_5/2)情况下比在单j壳(i_13/2)情况下更规则,而当组态空间从单j壳(i_13/2)扩大到双j壳(i_13/2+g_9/2)时,系统的混沌程度变化不大.同时比较了将6个粒子的两体相互作用分别取为δ力和对力时的系统的混沌行为     

Soliton interaction under the influence of higher-order effects

In this paper, we present exact N-soliton solution by employing simple, straightforward Darboux transformation based on the Lax pair for Hirota equation, a higher-order nonlinear Schrödinger (HNLS) equation. As examples, one- and two-soliton solutions in explicit forms are given and their properties are also analyzed. A bound solution without interaction will be theoretically predicted if one can adjust frequency shift for each soliton appropriately. Further, we obtain the approximate eigenvalues by employing two-soliton solution and discuss analytically the interaction between neighboring solitons under the influence of the higher-order effects. It is shown that the combined effects of the higher-order effects can restrain the interaction between neighboring solitons to some extent. The results are proved by directly solving HNLS equation numerically.     

A High Power Conversion Efficiency L-Band Erbium Doped Fiber Amplifier

By using two sections of erbium doped fiber and a fiber optical reflector, a novel, highly efficient L bandamplifier is demonstrated with significantly power-conversion-efficiency enhancement and the gain increasing of as much as 13 dB.     

Effects of B′-site transition metal on the properties of double perovskites Sr2FeMO6 (M=Mo, W): B′ 4d-5d system

The crystal structure, magnetic and magnetotransport properties of the variation of B′-site transition metal in Sr₂FeMO₆ (M=Mo, W) with double perovskites structure have been investigated systematically. Measurements of magnetization vs. temperature at H=5 T show that Sr₂FeMoO₆ is a ferromagnet and Sr₂FeWO₆ is an antiferromagnet with T_N∼35 K. Additionally, the large magnetoresistance ratio (MR) of ∼22% (H=3 T) at room temperature (RT) was observed in the Sr₂FeWO₆ compound. However, the Sr₂FeMoO₆ compound did not show any significant MR even at high fields and RT (MR∼1%; H=3 T and 300 K). The implications of these findings are supported by band structure calculations to explain the interaction between the 4d(Mo) and 5d(W) orbitals of transition metal ions and oxygen ions.     

High photosensitivity in cis-polyphenylacetylene films irradiated with 60Co γ-ray

This paper reports that ⁶⁰Co γ-ray irradiation can convert cis-polyphenylacetylene (cis-PPA) films prepared with rare-earth coordination catalysts to highly photosensitive materials. The dependence of the photosensitivity on irradiation dose, preparation methods, and microstructure of the PPA films has been investigated by means of a potential discharge technique. The photosensitivity was enhanced with increasing irradiation dose. The critical dose to produce a light response was 5 × 10³ Gy. The maximum surface potential discharge rate was 618 V/s, and the dark decay was approximately 2 V/s for cis-PPA films irradiated with ⁶⁰Co γ-ray (dose: 2 × 10⁵ Gy). The cis-transoidal-PPA and an electrophotographic photoreceptor device incorporating cis-PPA showed a higher irradiation effect. The structure and properties of ⁶⁰Co γ-ray irradiated rare-earth PPA films are similar to the unirradiated films.     

Reciprocating sliding wear behavior of laser-clad small amplitude Mo2Ni3Si/NiSi metal silicide composite coatings

Mo₂Ni₃Si/NiSi metal silicide composite coatings with a fine microstructure consisting of Mo₂Ni₃Si primary dendrites and the interdendritic Mo₂Ni₃Si/NiSi eutectics were fabricated on austenitic stainless steel AISI 321 by laser cladding process. Small amplitude reciprocating sliding wear resistance of the coatings is evaluated as functions of normal load and slip amplitude and the wear mechanisms were discussed based on worn surface morphology observations. Results showed that the Mo₂Ni₃Si/NiSi coatings have excellent small amplitude reciprocating sliding wear resistance.     

A lithium ethyl­ene­diphos­phon­ate containing lithium chains and symmetric hydrogen bonds

In the title compound, catena‐poly[lithium‐μ₃‐ethyl­ene­diphos­phon­ato], [Li(C₂H₇O₆P₂)]_n, the supra­molecular monoclinic (C2/c) structure consists of one‐dimensional lithium chains [Li⋯Li = 2.7036 (8) Å] that are embedded within ethyl­ene­diphosphon­ate anions linked by strong symmetric hydrogen bonds [O⋯O = 2.473 (3) Å]. The Li atoms and the H atom in the symmetric hydrogen bond reside on twofold rotation axes and there is an inversion center at the mid‐point of the C—C bond of the ethylenediphosphonate ligand.     

Hybrid Electrodes Used in Polymer Electro-Optic Modulator with Ultra-Broadband

Hybrid electrode combined coplanar waveguide (CPW) and microstrip lines in ultra-broadband electro-optic modulators. The characteristics of the modulators with hybrid electrode is like that of the modulator with the microstrip lines, in which the microstrip electrode is loaded above only one arm of Mach-Zehnder (M-Z) optical waveguide, besides the problem of microstrip line to coaxial transition and corona polarization in polymer modulators have been best solved at the same time. By using finite element method (FEM), the characteristic parameters such as half-wave voltage, modulation bandwidth characteristic impedance, effective microwave refractive index of polymer modulators with microstrip line and hybrid electrode are analysed and compared in this paper. The results present that velocity match, impendence match and lower microwave propagating loss is easily realized in modulators with hybrid electrode.